How To Correct Fiero Bumpsteer
|
Place a 1/2-inch USS flat washer (USS has a large OD compared to SAE) over a 1/2x2-inch hex bolt and pass the bolt through the 3/4-inch rod end. Slip a 1/2-inch SAE washer onto the bolt, apply thread-lock compound, and engage the rear end of the knuckle adapter bracket. Tighten the bolt to 80 lb-ft.The spherical bearing end of the link mounts to the vacant threaded hole on the front end of the knuckle adapter bracket. Again, using a 1/2x2-inch bolt and two 1/2-inch SAE flat washers, sandwich the 5/8-inch rod end to the front of the knuckle adapter bracket. Be sure to apply thread-lock compound to the bolt and tighten to 80 lb-ft. This outlines the installation of one side and should be repeated for the remaining side. When complete, the wheel alignment should be set before driving the vehicle. View Related Article
|
|